Getting Started With MDD3A Motor Driver Using Arduino

In this tutorial, I will slhow you how to get started with MDD3A motor driver.

INTRODUCTION

MDD3A is a motor driver which have the same concept like Maker Drive but with the higher specs. In this tutorial, I will show how to get started with MDD3A motor driver using Maker UNO (Arduino).

VIDEO

This video will show you how to get started with MDD3A motor driver using Maker UNO (Arduino)

Untuk versi bahasa Melayu, sila rujuk video dibawah.

HARDWARE PREPARATION

Below is the list of the items used in the video.

Wiring connection table.

Maker UNO MDD3A DC Motor Battery
  Terminal M1A Motor 1  
  Terminal M1B Motor 1  
  Terminal VB+   Positive
  Terminal VB-   Negative
  Terminal M2A Motor 2  
  Terminal M2B Motor 2  
Pin 3 Pin M1A    
Pin 9 Pin M1B    
5V 5Vo    
GND GND    
Pin 10 Pin M2A    
Pin 11 Pin M2B    

Sample Code

For the sample code, you can utilize the example code provided in Cytron Motor Drivers Library. Please install the library in Library Manager first. Then, open PWM_PWM_DUAL example (File – Examples – Cytron Motor Drivers Library – DUAL_DUAL_PWM).

Thank You

References:

  1. Getting Started with Maker Drive and Arduino

Thanks for reading this tutorial. If you have any technical inquiry, please post at Cytron Technical Forum.

Leave a Comment

Your email address will not be published.

Share this Tutorial

Share on facebook
Share on whatsapp
Share on email
Share on print
Share on twitter
Share on pinterest
Share on facebook
Share on whatsapp
Share on email
Share on print
Share on twitter
Share on pinterest

Latest Tutorail

ESP32 PD Line Following Robot with Maker Line
Raspberry Pi Line Following Robot with Maker Line
Magnetic Contact Switch Sensor with Arduino.
Control MDDS30 In Serial Simplified Mode Using Raspberry Pi
Control A Servo And Display Sensor’s Reading Using The GUI On Arduino.
Scroll to Top