Bukit Mertajam, Penang

Getting Started with Maker Drive and micro:bit

Introduction

Maker Drive is a dual channel motor driver which is designed for beginner. It can be interfaced with 1.8V, 3.3V & 5V logic controller like Arduino boards, micro:bit, Raspberry Pi and etc. This tutorial will share with you on how to get start with Maker Drive using micro:bit.

Video

This video will show you on how to get start with Maker Drive using micro:bit.

Untuk versi bahasa Melayu, sila rujuk video dibawah.

Hardware Preparation

Item used in the video

Wiring connection table

micro:bit Maker Drive DC Motor Battery
Pin 1 Pin M2A
Pin 2 Pin M2B
Pin 3 Pin M1A
Pin 4 Pin M1B
GND GND
Terminal M1A DC Motor 1
Terminal M1B DC Motor 1
Terminal VB+ Positive
Terimnal VB- Negative
Terminal M2A DC Motor 2
Terminal M2B DC Motor 2

Sample Program

This is sample code used in the video. I’m using Microsoft MakeCode.

Thank You

References:

  1. Microsoft MakeCode
  2. Maker Drive Datasheet

Thanks for reading this tutorial. If you have any technical inquiry, please post at Cytron Technical Forum.

Related Posts

Leave a comment