Getting Started of GY-521 MPU6050 with Arduino (Maker UNO)

INTRODUCTION

The MPU-6050 is a serious little piece of motion processing tech! By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an onboard Digital Motion Processor™ (DMP™) capable of processing complex 9-axis MotionFusion algorithms, the MPU-6050 does away with the cross-axis alignment problems that can creep up on discrete parts.

This tutorial video will show you how to interface GY-521 MPU6050 with Arduino.

Hardware List:

  1. GY-521 MPU6050 6DOF Accelerometer + Gyro
  2. Maker UNO
  3. Breadboard 8.5×5.5cm
  4. Acrylic Base Plate for Arduino Uno
  5. Male to Male Jumper Wire

Leave a Comment

Your email address will not be published.

Share this Tutorial

Share on facebook
Share on whatsapp
Share on email
Share on print
Share on twitter
Share on pinterest
Share on facebook
Share on whatsapp
Share on email
Share on print
Share on twitter
Share on pinterest

Latest Tutorial

Getting Started With ProjekIoT.com Using Raspberry Pi
Control Servo With Gesture Using ESP32 and Arduino
Send Sensor’s Data to ThingSpeak Using ESP32
Basic Usage of iMAX B6AC LiPo Charger
Colourful Bed Lamp Using Tilt Sensor on Maker UNO
Scroll to Top